structure of thin film造句
例句與造句
- It was found that the concentration of tea and ammonia is very important for the sns thin film quality . xrd and sem were employed to study the structure of thin films
分析結果表明：反應物三乙醇胺的濃度、溶液的ph值對反應有很重要的影響，氯化銨的加入對溶液ph值有穩定作用。 - Based on laser molecular beam epitaxy , the strain behavior and the corresponding control technology in oxides heteroepitaxial system , especially in ferroelectric thin films with perovskite structure , was systematically studied by using in situ reflected - high - energy - electron - diffraction ( rheed ) . some original and meaningful results were obtained . following aspects were included in this dissertation : the structure of thin films is analyzed by rheed
本論文基于激光分子束外延的基本原理,以高能電子反射為主要監測工具,對氧化物薄膜特別是鐵電氧化物薄膜異質外延過程中應變行為及其控制方法進行了系統的研究,并取得了一系列有意義的結果,主要包括以下內容:利用反射高能電子衍射( rheed )的信息對薄膜結構進行分析。 - Based on the analysis of relationship between the deposition rate and the deposition conditions ( the main factor : substrate tenperature , teos temperature and deposition time ) , it is proved that the maximum deposition rate and the optimum surface state , structure of thin films are to be gotten , when the temperature of substrate is 500 to 600 c , the pressure of the reactor is 260 to 400 pa , the temperature of teos is about 60 c , current is 1ml . s - 1
在成膜機理的基礎上，通過對不同沉積條件(如沉積溫度，物源溫度，沉積時間)下沉積速率和薄膜結構形態的測試和分析，我們發現，當系統的實驗條件為：基片溫度500 ? 600 ，反應室壓力260 ? 400pa ， teos的溫度在60左右，流量1ml s ~ ( - 1 )時將獲得最佳沉積速率和膜的最佳結構形態。 - It's difficult to find structure of thin film in a sentence. 用structure of thin film造句挺難的